how to clean kenmore washing machine filter top loader?

There are a few ways to clean the filter on a top load washing machine. One way is to pour a pot of hot water into the washing machine and add 1 cup of white vinegar. Turn the machine on and wait until the wash cycle is complete. Remove the filter and rinse it with cold water. Repeat this process two more times, or until the filter is clean.

There are a few ways to clean the lint from your Kenmore top load washer. One way is to pour a cup of white vinegar into the washer, turn it on, and wait until the vinegar has cleaned the lint off of the machine. Another way is to pour a cup of white vinegar and one cup of water into the washer, turn it on, and wait until the vinegar has cleaned the lint off of the machine.

Top loading washing machines do not typically have filters to clean. Instead, the water is forced through the clothes as it spins, helping to remove any dirt or debris.

Yes, Kenmore washers have filters. The filters help to remove dirt, dust, and other debris from the clothes washer.

The filter is in the front of the top loader washing machine.

To clean a Kenmore 700 Series top load washer, first remove the lid and remove the washable filter. Pour a small amount of detergent into the tub and turn on the washer. Agitate the clothes to distribute the detergent. Wipe down all surfaces with a dry cloth. Replace the washable filter and lid.

The Kenmore washer filter is located on the top of the machine.

The coin trap is typically on the top of the washing machine.

There is no one definitive answer to this question since it can vary depending on the model of washer and where it is located. However, some tips to locating a washer lint trap may include looking for a round or oval-shaped opening in the front or rear of the machine near the top or bottom, respectively. If you can’t find the trap, you may need to remove the front panel of your washer to access it.

The best way to clean a top loading washing machine with an agitator is to first remove the clothes and then use a bucket filled with hot water and detergent to rinse the machine.

To empty the washing machine filter, first unplug the washer and wait 10 minutes to allow the water in the machine to cool. Next, remove the bottom panel by pulling up on the lip and then lifting out. Find the filter and unscrew it. Pour out the dirty water and replace the filter. Replace the bottom panel and plug in the washer.

There are a few ways to clean sediment out of a washing machine. One way is to use a plunger. Put the plunger over the drain opening and push and pull the plunger until the sediment is cleared out. Another way is to pour a cup of white vinegar into the washer, turn it on, and wait 10 minutes. Pour a cup of water into the washer, turn it off, and empty the water out.

The best way to clean your Kenmore washer cycle is to use a small amount of white vinegar and water. Pour 1/2 cup of white vinegar into the washer’s dispenser and turn on the machine. Add enough water to fill the washer’s tub. Close the lid and wait until the wash cycle is complete. Pour out the vinegar and water, and dry the machine with a cloth.

To clean a Kenmore washer model 110, first remove the water and detergent container. Pour 1 cup of white vinegar into the washer and turn it on to the hottest water setting. Once the machine has started filling with water, turn it off and open the door. Pour out all of the water and detergent and replace them with 1 cup of white vinegar. Close the door and turn the machine on to the wash cycle. Let it run for 30 minutes.

Most washing machine filters are located in the front of the machine.